 |
ALL-PURPOSE HANGER 60/125 It is used for fastening of CD profiles during installation of the suspended gypsum plasterboard ceiling to the wall partition and to the cladding. It is fastened to the ceiling and wall with the expansion dowels, to CD profile – with the self-drilling screws. |
 |
ROTATING HANGER WITH EXPANDING ELEMENT It is used for CD profiles during installation of the suspended gypsum plasterboard ceiling frame. It is used together with the ring bar. |
 |
SINGLE-LEVEL CONNECTOR “CROSS-CONNECTOR” It is used for connection of CD profiles in orthogonally related directions during installation of the one-level suspended gypsum plasterboard ceiling frame. |
 |
TWO-LEVEL CONNECTOR It is used for connection of CD profiles in orthogonally related directions during installation of the two-level structure of the suspended gypsum plasterboard ceiling. |
 |
LONGITUDINAL CONNECTOR It is used for longitudinal connection or extending of CD profiles during installation of the wall and suspended gypsum plasterboard ceiling frame. |
 |
CORNER CONNECTOR It is used for corner connection of CD profiles in cross direction during installation of the one-level structure of the suspended gypsum plasterboard ceiling. |
 |
SPRING HANGER “BUTTERFLY” It is used for fastening of the suspended ceiling. It is used together with the ring bar and hook bar. |
 |
RING (HOOK) BAR 125-200 MM It is used for fastening of the suspended ceiling and decrease of the height of the suspended gypsum plasterboard ceiling with respect to the floor slab. It is used together with the rotating hanger for CD profile or together with the ring bar and together with the spring hanger (butterfly). |
 |
SCREED STRIP The screed strip is used as a support guiding base for obtaining the plane surface during plastering. The screed strip enables selecting the plaster laying thickness and obtaining the plane plastered surface in quick, accurate and low-cost manner. Usually, the guides are made of galvanized steel for application of 6- and 10-mm plaster layer. |
 |
ANGLE SECTION FOR WET PLASTER The angle section for wet plaster is used for strengthening of the wall corners, door and window frames during wet plastering. It is recommended to use this angle section with non-aggressive plasters to prevent destruction of the zinc-plated layer.
|